Precision Marine Installations by Radioworld

08/25/2026

08/24/2026

Ranger Z185 in for a complete re-rig from bow to stern ⬇️

✔️ Garmin LVS34 with the GeigerTec Scope Switch on the Minn Kota Ultrex Quest
✔️ Flexroute Cable Management keeping the LVS34 cable away from pinch points and fixed on the shaft
✔️ New Dual Live Mount from GeigerTec with the Over the Pedal Offset Bar — Extension Pole option for hard core scoping
✔️ BBT Ranger Z185 Dual Dash with two new Ultra 2 Echomap 106SV from Garmin with the GT56 off the transom
✔️ Garmin GPS24XD GPS Puck and NMEA Network
✔️ GLS10 relocation into the starboard locker for easier access and serviceability
✔️ Battery compartment overhaul featuring an Apex Lithium 160ah battery to run the motor, pumps, and electronics
✔️ Dual Bank Charger for 12V / 36V Battery Configuration from Apex Marine
✔️ SeaClear Power Wiring Harness to isolate the electronics from factory wiring, delivering clean power and no voltage drop
✔️ Dual 36V trolling motor battery configuration

08/18/2026

This Nitro Z20 that we have been referring to as “Spider-Man” around the shop, came in for some crucial mid season upgrades 👌 ⬇️

✔️ Garmin LVS34 Upgrade from the LVS32, mounted on the GeigerTec Scope Switch and routed as cleanly and securely as possible with the Flexroute system
✔️ GeigerTec Nitro Z Series Bow Plate with Dual Extreme Mount holding the Lowrance HDS9 and Garmin 106SV
✔️ GeigerTec Dual Dash mount secured for the toughest of waters, holding a Lowrance HDS12 and Garmin 106SV
✔️ Garmin and Lowrance Network Configurations
✔️Apex 142AH Starting Battery running the boat and powering the electronics with the SeaClear Power Harness
✔️ Battery compartment tidy with new connections and some software updates to wrap it all up!

08/17/2026

Everything about this Skeeter WX was a tight squeeze 🤏 ⬇️

✔️ Dual Extreme Mounts at the dash to accommodate a 10 and 12” Humminbird Helix
✔️ Dash mounting reconfiguration to fit the Fish Hawk and it roll displays/modules
✔️ Dual Circuit shut off switch installation for starting/electronics circuits and electronics harness re-location/modification
✔️2x oversized 36V trolling motor batteries, and 2x Group 31 batteries for starting/electronics jammed into this battery compartment
✔️ NOCO 10x1 Charger for the electronics battery and a compartment tidy with new connections where needed

08/14/2026

Garmin 9213XSV and LVS42HD Upgrade on the bow of this Skeeter!

4K resolution on the GPSMAP paired with the clarity of the 42HD transducer will leave nothing hiding under water for this customer!

08/11/2026

Full factory re-rig on this 2026 Legend 19XT topped off with an on-the-water session to get these customers dialled in and comfortable with their new setup ⬇️

✔️ Trolling motor upgrade from the Terrova Quest to the Ulterra Quest with Auto Stow and Deploy features
✔️ Precision Sonar Ulterra Quest FFS Mount for the Mega Live 2
✔️ We replaced the ethernet cable on the ML2 as the original one was damaged due to poor wire routing
✔️ GeigerTec Extreme Mount on the bow for the Humminbird Xplore 12 CHO
✔️ Dash Xplore 10 CMSI+ addition on a GeigerTec Extreme Mount
✔️ 5 Port Ethernet Hub Installation and full One Boat Network configuration
✔️ New 6awg trolling motor wiring harness ran to the back of the boat to give more bow storage and bypass the plug at the bow
✔️ Dual 36V 60AH Apex Lithium in parallel for 120AH on the trolling motor side
✔️ Apex Lithium 142AH on the starting/electronics side
✔️ Apex 2 Bank 12V/36V charger
✔️ Addition of a master power switch
✔️ SeaClear Power Harness to power the electronics with no voltage drop and cleanest, most dependable power available

This customer opted for the On-The-Water session to go over the full setup and dial in the settings for imaging, and One Boat Network configuration

07/29/2026

Livescope 2 rigging in full swing! We’ve got LVS44’s going on customer’s boats, and on-the-water videos in the works 💪

LVS42 HD transducers are expected to start making their way in soon as well 📦

07/28/2026

This Lund 1875 Pro Guide came into the shop earlier this summer with 0 hours of use on it, for a full Garmin build ⬇️

✔️ Garmin Kraken Force 63” with GT56 on a Quick Release Mount with optional Foot Pedal
✔️ Garmin 95SV UHD2 and 126SV Ultra 2 Echomap Setup on the GeigerTec Dual Extreme Mount
✔️ Garmin LVS34 on a pole mount with dual bulkhead locations on the boat for ease of maneuverability
✔️ Dual Garmin Echomap dash setup with a 106SV Ultra 2 and 95SV UHD2 on GeigerTec Extreme Mounts
✔️ Garmin GMS10 network module tying all units and transducers together for seamless integration
✔️ Apex 142AH Dual Purpose Battery to power all electronics and take care of the engine
✔️ Dual Apex Lithium 105AH batteries in series for 24V for the trolling motor
✔️ NOCO 10X3 Charger
✔️ Custom wiring harness that meets this customers needs
✔️ Large Transducer Mounting board with GT56