Boatique Services

05/06/2026

Composite and epoxy transoms

04/06/2026

Seafarer Coosa and epoxy transom replacement raised to XL height, check out the process...

Some of you may have seen this boat in our posts before, in fact its been in our shop a number of times! We started with refurbishing the hull underside section, then on another visit we repaired the floor, then the biggest undertaking, we designed and built a custom integral composite windscreen wh...

26/05/2026

Dry Rot is a curse to boats however it is a relatively easy fix. Check out this job we did on this houseboat...

Most houseboats are built with a timber frame and plywood exterior which can let water into the timber and cause rotting. This can often stem from screws or bolts that work loose and allow water ingress. This houseboat had rot in the front brow over the windscreen on the upper deck and also in the [...

21/05/2026

Disaster!! There's water coming into the boat! Never what you want out on the water, check out how we repaired this open gash in the keel...

This Cox Craft had sustained significant damage to the keel near the bow, resulting in water ingress. The vessel was lifted onto work stands so repairs could be carried out. The damaged area was prepared and rebuilt using multiple layers of fibreglass cloth and epoxy resin to restore the hull skin.....

19/05/2026

We rebuilt the aft section of the hull on this Stejcraft and added a new bait tank!!

The owner of this Stejcraft contacted us about a serious crack in one of the spray rails that was allowing water into the hull. As the owner was located outside our service area and unable to bring the boat in initially, we provided an estimated repair cost based on photographs supplied to us. Once....

13/05/2026

We machined some EVA Foam Pads for a wake boat, check it out!

We recently machined some pads for a customer with a wake boat, including a custom logo on the swim platform. These pads will be fitted by the owner who also supplied the templates. We look forward to seeing photos of these once fitted!

13/05/2026

The back mooring cleat got ripped off!! Leaving the cleat scratching the boat all night! Check out how we carried out the repairs...

The deck cleat on this corner takes most of the load if a Southerly front comes through and unfortunately it was enough to sheer the bolts and leave some ugly gelcoat damage. The gelcoat repairs surrounding the cleat took some time to match and polish in but the result was worth it. The cleat was [....

30/04/2026

Check out the pair of custom EVA panels we installed on this Wave Runner ski...

30/04/2026

Jetskis are fast and damage can happen quick! Check out the hull repairs on this one, and some custom EVA foam panels we did...

The owner of this Wave Runner ski suffered some nasty hull damage from grounding. He also asked for a touch-up on the deck and some custom EVA panels fitted for when he loads his surfboards in the footwells. For the hull work, the ski was lifted onto work stands and the hull bottom repaired.

28/04/2026

Boat building, repairs or restorations!