Redline Customs SD

11/29/2025

Had a good time doing the final welding on my friends Chassis for his Model A project.

04/05/2025

Rat Rod switch panel almost done and ready for install

03/02/2025

02/28/2025

Looks like it’s gonna be another busy weekend, last weekend we pulled the motors out of the Sprint Car, and out of an old plow truck to possibly use in the Rat Rod project. This weekend we’ll try to breathe life into both of them to see what we got to work with. Always got something going on! 

02/06/2025

Looking for recommendations on how to slow down time to get all my projects done,,TIA

08/04/2024

I’ve shared this one before but wanted to show again one of my side projects that I’ve been working on with my compadre Andy Dicus. I threw some parts at it this week and took it to a show just to get it out of the shop.
The list is long to get this thing done but looking forward to getting it knocked out and on the road in the spring/summer.
1948 Ford F1 Pickup with a 5” Chop, 400 Chevy engine, Muncie 4-Speed, ‘72 Camaro front subframe grafted to a custom built rear frame section, Ford Explorer rear axle, 4-Wheel disc brakes.
Thanks for looking, Cheers

01/29/2023

Single digits outside today, good day to be in the shop and work on some motor projects and watch some NFL championship games!

01/09/2023

Happy New Year Y’All!!
With the coming of a new year comes a new project(again)!
My ‘66 Nova got pulled out of storage this summer after being put away for more than 10 years!! Hey, I’ve been busy!!
The car has a long way to go to get back to where it used to be when my brother Brian Derheim and I redid this car back in the mid-90’s but made some baby steps towards getting there over the last couple weeks. 10 year old gas didn’t treat my gas tank or sending unit very well so new ones are on the way. Some other parts are through with sandblast and are painted or waiting for powdercoat. Next week the Ford 9” Rearend will get disassembled and gone through along with some trunk cleanup. LOTS to do, Thanks for looking, Cheers

P.S. I attempted homemade tortillas today!

02/27/2022

Always fun to bring an engine back to life after a long time of extended storage. This 350 SBC is going to be used in my friends Scout project

02/12/2022

Sometimes all you can do is balance the good with the bad,, I dropped off an engine block at the machine shop that didn’t last longer than 20 minutes on my engine run stand before it chunked the bearings and scarred the crank! Oh well, lessons learned, next time build it bigger, badder, better.
The good news is that I got another engine block back from the machine shop that I’m looking forward to putting together this weekend. I also learned how to make Lefse!